Hydraulic shaping machine KZY tub tub manufacturers 1T tub shaping machine plastic machine plastic machine specification parameters KZY tub Shanxi hydraulic tub tub Chifeng plastic machine plastic machine plastic machine tub Jining latest sales shaping machine in factories and enterprises in the production process , tub as the basic means of transport, the use of high strength, high turnover, often corresponding wagon deformation, etc., relying solely on hammering, artificial way maintenance is difficult to achieve the desired effect, and led to many of the tub should be scrapped advance into the end of life, greatly increasing the coal production cost. Plastic tub machine is suitable for the type of casing deformation tub repair, can also be used to track, metal beams and other rigid stand corrected after deformation, deformation is performed reconstructive tub designed for specialized maintenance equipment, machine is suitable for 6mm thick steel tub below. Plastic tub machine is mainly composed of hydraulic station, control mechanism, composed of four parts moving mechanism, plastic body shaping machine tramcar operation process: 1. The vertical plate with two plastic cylinder head installed in I, II in two on. 2. The operation of the lift cylinder cylinder rod protruding arm of the U-type plastic tub to be shifted to a position just above the oil valve handle to move back to its original position, and beam shaping machine tub underneath. 3. Operation plastic cylinder II, the cylinder rod extends the oil valve handle to move back to its original position. 4. Operation Pan cylinders, so that the center of the U-shaped arm alignment of the tub, the median length of the oil valve handle to move back to its original position. 5. Operation lift cylinder, flat plastic cylinder head so I close on the protruding parts. The oil valve handle to move back to its original position. 6. plastic cylinder head flat on I as plastic extrusion force of support. Operation plastic cylinder II, II makes plastic cylinder cylinder rod is retracted, the two head to the inside at the same time squeezing protruding parts, and so restore the original state, the handle to move back into place. 7. When operating the lift cylinder, the cylinder rod is retracted so that the work of the U-shaped arm rose above the edge of the tub, the oil valve handle to move back to its original position.