Electric pump using an electric pump electric pump SB pump stainless steel explosion-proof electric pump electric pump corrosion resistant pump price of electric drums pump manufacturers SB series electric pump, pump electric pump can be inserted directly into the material bucket (maximum applicable in line with GB / 325-1991 standard drums) to extract a barrel of liquid. Widely used in chemical, petrochemical, fine chemicals, dyes chemical, environmental protection, water treatment, pharmaceutical, food and other departments pumping different liquids. Can transport all kinds of oil, corrosive chemical medicine, and other liquids, while for small and medium oil fields, oil depots, refineries, gas stations, agricultural stations, enterprises, fleet vehicles, ships and other transport gasoline, kerosene, diesel, light fuel oil. According to the liquid nature of the transmission, pump pump wet part of the material could be aluminum, stainless steel, 316 stainless steel. Drive motor is equipped with a wide selection of standard single-phase motors, explosion-proof motors, high speed motors. Depending on the material, motors, models can be divided into: SB-1, SB-2, SB-3, SB-3-1, SB-4, SB-5, SB-6, SB-7, SB-8 Series Aluminum alloy, stainless steel, or explosion-proof. Electric pump maintenance: 1, the regular greasing, electric drums pump for high-speed operation, grease is as volatile as it is necessary to lubricate the bearings can be kept clean, and pay attention to Tim change. 2, regular inspection and maintenance of electric drums pump, electric drums pump should be inspected regularly, maintenance, must check the power cord: internal wiring, plugs, switches is good, the insulation resistance is normal, the tailstock is a matter of loose brush, commutator and brush good contact, expanding the stator windings of the armature winding level if there is a moderate circuit phenomenon, bearings and rotating parts for damage, and so on. 3. Keep the same every parts and replacement parts when dismantling the electric pump, should keep every part, paying particular attention to the parts of explosion proof surface so that it can not damage the nap includes an insulating spacer and the casing, such as damaged, must exchange the same on the new parts should not be used less than the raw performance of alternative materials or does not match the original specifications of parts, all parts of the assembly should be installed according to the original location, can not be missed. 4. Note that the insulation resistance of the electric pump oil drums, electric shelved indefinitely or for use in wet environments without the pumping pump, winding insulation resistance must be measured with a 500 volt megger before use. As between the windings of the motor housing is less than 7 megohms insulation resistance, the windings must be dried. 5, pay attention to save the electric pump should be kept in a dry, clean and free of corrosive gas environments.